NEW GENUINE ASTON MARTIN

CLEAR SELF ADHESIVE

STONE CHIP PAINT PROTECTOR

UPPER LEFT SIDE TAPE

NUMBER 2 IN THE PARTS DIAGRAM

INSTALLING:
Clean the surfaces, ideally with a degreaser
Spray the film with the fitting solution (water & soap), whilst removing the backing
Do not touch the adhesive side when dry, as this will leave marks
Spray your fingers with the fitting solution before removing the backing
Lay the film onto the bodywork and slide into position to match the diagram supplied
Once happy with its location, spray with fitting solution so the squeegee will slide across it, before slowly using the squeegee to apply pressure and push out the air and moisture from below the film
For curved sections, apply some stretching force to get the contours of the bodywork and avoid creasing
If you are unhappy with the position, remove and start again
Continue working the film with the squeegee until all air bubbles are out and the edges are securely in place, if any edges are not sticking down, apply some pressure with your thumb for a few seconds
Finally, use a heat gun or a hair dryer will also work, to slowly warm the film and ensure adhesion, especially on the edges

THERE ARE SOME GREAT YOUTUBE VIDEOS ONLINE WHICH MAY HELP