NEW GENUINE ASTON MARTIN PARTS

WHEEL NUT ALSO KNOWN AS A LUG NUT

THREAD SIZE M14 X 2.0 MM

The 22mm wheel nuts (4G43-1K024-AD) installed to early DB9 and V8 Vantage vehicles are no longer available to purchase from Aston Martin
If a wheel nut replacement is necessary for these vehicles, a full vehicle set of 21mm wheel nuts must be installed
CAUTION: DO NOT USE A MIX OF 21MM AND 22MM WHEEL NUTS ON THE VEHICLE.
DIFFERENT SIZE WHEEL NUTS USE DIFFERENT TORQUE VALUES.
THE SAME SIZE NUT SHOULD BE USED TO MAKE SURE THE SAME TORQUE IS APPLIED FOR EACH WHEEL NUT
When 21mm wheel nuts are installed, the below torque procedure must be used and not the torque values listed for 22mm wheel nuts
1. Torque each wheel nut on a wheel to 80 Nm (60 lb.ft)
2. Torque each wheel nut again to 180 Nm (133 lb.ft